Concept photograph of a small accessory keypad on a vehicle console and a separate closed control box on the passenger seat.

A Switch Panel Needs Two Mounting Plans: Keypad and Control Box

Choose the keypad position for clear, comfortable access. Choose the control-box position for a secure installation, suitable surroundings and future service. Treating them as two separate decisions is more useful than finding an empty patch of dashboard and assuming the rest will fit.

The VASTFIRE switch panel kit uses a separate switch panel and control box. That gives you two components to accommodate; it does not mean the box can be installed anywhere on any vehicle.

Begin with a removable mock-up

While the vehicle is parked, place a paper outline of the proposed keypad at the intended location. Use confirmed dimensions for the version you are considering. Leave any mounting holes until the position and hidden space have been checked.

Sit normally, adjust the seat and use the factory controls around that outline. Can you still reach the hazard switch, vents and storage? Does a cup, gear selector or charging cable hide the lower row? If the truck is shared, repeat the check with another driver's normal seat position.

The test is about the layout, not permission to operate accessories while driving. It also cannot identify what is behind the trim. Have the installer check the vehicle's service information and keep mounting hardware clear of safety equipment.

Leave room to service the box

A control box that fits into a gap may become inaccessible once other parts are reinstalled. Ask how its cover, connectors and relevant protection can be reached without dismantling unrelated equipment. Think about the space needed to disconnect a plug, not just the outside dimensions of the closed enclosure.

Confirm whether the proposed environment is permitted for that exact version. A photograph showing a box near an engine is not a temperature or water-resistance specification. The supplied VASTFIRE materials do not give us a verified rating to apply to every possible mounting location.

There is no universal answer such as “under the hood” or “behind the dash.” The correct position depends on the enclosure's confirmed limits, the vehicle and the installation design.

Measure the route between the components

Ask for the actual included cable lengths and connector dimensions. Measure the route the cable would follow, including turns, existing passages and enough service access. The straight-line distance between the keypad and box is not the cable route.

Do not extend a lead or substitute a connector simply because the shapes look familiar. If the supplied arrangement cannot reach both approved mounting positions, discuss a supported alternative before buying. Moving the keypad slightly may be a better solution than committing to an unverified extension.

The accessory wiring needs its own plan as well. A keypad location tells you little about how the lights, supply and protection will be connected.

Once both positions are agreed, save a photograph of each location and a note identifying which component is there. This is useful when the vehicle returns for service or another accessory is added. If you are still deciding on the layout, send those photos with the accessory list through our contact page. Include the selected 8 or 12 Gang version so the discussion stays attached to the correct hardware.

Back to blog

Leave a comment